![]() ![]() In the drop down menu over display filters, if is passable to change floor and room. In the display filter select the node number of your Z-Wave device in the floor selection, select “check all” in room and device type.Ĭheck the box beside the Z-Wave device and/or the child devices. You can see this number in the window with Operational messages or go to the top drop down menu “PLUG-INS” – “Z-Wave” – “Node Information”.Īll HomeSeer included Z-Wave devices are listed here.įind the one you just added and see if every thing seems okay.įor editing the name, floor or room of your new Z-Wave device you need to go, to the home screen, you do this by clicking on “Home” in the top menu. ![]() ID numbers, also called Node numbers, is needed to configure the Z-Wave device. Typical it is done by pressing a button on the Z-Wave device, 3 times within 3 seconds. This will set your Z-Wave controller in include mode, you need to do the same for your Z-Wave device. When the Z-Wave device is ready to be added/included to the Z-Wave network click “START”. We need to add a new device, so here you select “Add/Include a Node”. It is the place if you need to optimize your Z-Wave network, after you have added a lot of Z-Wave devices, or if a devices is not working the way it should, you can re-scan the device from this drop down menu. In this menu you can do a lot with your Z-Wave controller. Select the port for the Z-Wave controller and click “Add”.Īfter clicking add you will see a new drop down menu called Actions. Select the drop down menu “Serial Port”, it will only display the port numbers that are active on the HomeSeer server. ![]() The one I’m using is “ Aeon Labs Aeotec Z-Stick“.Īfter selecting the interface for your Z-Wave network you need to select the serial port of your Z-Wave controller. In the filed “Interface model” select the interface you are using. Now go to the drop down menu “PLUG-INS” in the top of the page and click “Z-Wave”, a page where you can create a new Z-Wave network will now show. The overview of installed plug-ins will now show the Z-Wave plugin, make sure that is set to “Enable”. You will see it under the section “Pending Updates / Installs”. In the middle of this page, expand the option “Additional Interfaces”, and “Lighting & Primary Technology” and find “HomeSeer Z-Wave”. When you have accessed the page in your web browser, go to the menu “PLUG-INS” and select “Manage”.Īll Installed Plugins are shown in this screen. If you are using a Windows based PC as your HomeSeer server you can see how the find the IP address here. You can access this by typing the IP address or hostname of your HomeSeer server. To add a new Z-Wave device to HomeSeer you need to go to HomeSeers web interface. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |